Signed in as:
filler@godaddy.com
Signed in as:
filler@godaddy.com
In this video, Stuart shows both spindle and bowl turning using the optimum tools for side and end grain surfaces and his negative rake scraping technique. This video also shows various bowl-chucking methods, including jam-chucking.
In this video Stuart Batty talks about grinding wheels for woodturning before showing how to create his 40/40 bowl gouge grind from scratch. Stuart also shows how to set accurate edge angle for a variety of tools he uses for both spindle and bowl turning.
Stuart Batty shows how he makes his rough turned bowls followed by showing how he finishes a dry bowl including jam chucking. This video includes both his 40/40 and bottom bowl gouge grinds and techniques as well as his Negative Rake Scraping. There is also a short section on grinding and sharpening the various blades used in the video.
Stuart Batty demonstrates his bowl turning techniques using his 40/40 grind during the August meeting of the Mid-Maryland Wood turners.
A demonstration by Stuart Batty of sharpening a bowl gouge to a 40/40 grind.
Negative Rake Scraping (2006)
Download PDF7 Fundamental Set Up Rules
Download PDF4 Ways Wood is Removed on a Lathe
Download PDFWhy Use a 40 Degree Angle for Slicing?
Download PDFSlicing vs. Peeling Blades
Download PDF40/40 Bowl Gouge Grind for Thompson V Bowl Gouges
Download PDFBottom Bowl Gouge Platter Grind for Thompson Deep U Gouge
Download PDF40/40 Elliptical Bowl Grind Photos
Download PDF